TV lifting system is mainly used for meeting room, office, home and other places of automation equipment.Fully automatic hidden type.It can make better use of space.

Product Features
      Remote control, one button lift
1: inside the pipe
In-pipe routing design, hidden lines, more
Easy to protect the wire, make the space more tidy!
2: Support 323/485 reservation
Reserved a hole for users to upgrade

3: A variety of joints, choose any

4: Bamboo lift
Telescopic design, the length of the trip can be customized
5: Inside the pipe
Hole space 45" 30MM, can put VGA, HDM
Power, network cable, etc.
6: Load bearing 25KG
Lifting column, aviation aluminum, lifting
The sound is more beautiful.

Single pole electric hanger installation
First, follow the product attachment bracket or the hole size on the template to mark the top of the ceiling corresponding to the false ceiling mounting hole with a marker.
Drill the drill hole to tighten the M8's expansion nut to the M8 corresponding long screw, then lift the hanger up, so that the four screws pass through the long waist hole in the upper part of the hanger
Before tightening and tightening with nuts, pay attention to adjusting the level and height of the hanger. When installing the decorative panel, fix the decorative panel with a suitable length of M8 rod
And to ensure the level of the decorative board, power supply to the device, use the remote control to set the upper and lower limits, to determine the no abnormal situation, you can install the projection
Machine, if the space height allows, you can use the appropriate size of the universal claw to fix the projector, if the height is not enough, you can use ordinary claws
The special adjustment bracket and screws are used for fixing to save installation space. After the projector is fixed, pull out the cable inside the rod and insert it in the corresponding
On the port, perform final positioning debugging and setup. Pay attention to the fixing fastness of the line system and the projector bracket to prevent accidental falling.

Remote control learning code
1. Press and hold the red button on the main unit until you hear a "drop" sound
Only let go.
2. Press the pause button again, and hear the sound of two “drops”, indicating remote control.
ニ: Electronic setting operation method for upper and lower limits
1: Press the set button, and hear the sound of five “drops” to cancel the original setting.
Start setting (Note: you must hear five sounds, the other sounds are invalid)
2: Lower limit setting
Press the lower limit button to lower the hanger when the hanger has lowered to your desired position
Press the pause button, the hanger stops to the position you want, then press the set button, listen
Two “drip” sounds are sent to the host to indicate that the lower limit is set successfully (the lower limit is selected)
The position can be repeated using the up and down keys)
3: limit setting
Ps: If the setting is unsuccessful, press the setting button to hear five “drops” and then reset