Features

1: New era of socket installation, new breakthrough in tempered glass

2: Three kinds of face values, the same burst table

3: Precision water drilling knife cutting technology --- accurate to 0.01mm, rounded corners / delicate side lines / texture, more different, thus highlighting your home decoration taste

4: 720 ° crystal clear - tempered glass crystal mirror

5:50μ gold-plated module---lower contact resistance guarantees stable and efficient transmission of network

6: Careful design, exquisite only for the picky you - using 3mm ultra-high temperature tempered glass panels,
Crystal clear, transparent, flame retardant and safer

installation steps

Step 1: Use a stripping tool or a crimping tool to strip the outer sheath of the twisted pair at about 10 cm in length (or a little longer, for easy back pressure). Four pairs of twisted pairs were exposed.

Step 2: Start the line. Do not disassemble the pairs before unpacking the corresponding pairs before pushing them into the string. Select our preferred line-sequence mode according to the color code indicated on the information module. (Note: It is best to use only one line-sequence mode in a cabling system. Otherwise, it will be unreasonable if the network is unreachable.)

Step 3: After pressing all the wires into each slot, use the tool to press the module and the line, press down firmly, clamp the line inside the module, and cut off the excess head.

The fourth step is to install the wired information module on the 86 box panel, so that the wall cable socket is installed.